Bamboo fiberboard is the latest environmentally friendly decorative material on the market. It is environmentally friendly and has good decorative effect. The surface is protected by UV light curing paint. It is wear-resistant, scratch-resistant, pollution-resistant, heat-resistant and cold-resistant. Favorite. Today, I will introduce the installation method of bamboo fiberboard for your reference.

 

 

 

First, install with wall glue

 

 

 

1, on the wall surface is covered with a base layer, commonly used is 3MM plywood, wood board, a good point is fire-resistant glass magnesium board. Use pneumatic nails to nail them to the wall and clean the board with sandpaper.

 

 

 

2, saw board, bamboo wood fiber board saw into pieces according to actual requirements.

 

 

 

3, the inverted side, the UV board to be installed on all four sides with a machine to pour into a 45 degree angle. According to the actual installation requirements, some only need to pour the top or bottom or three sides.

 

 

 

4. Clean the back of the UV board and clean the back of the UV board with sandpaper and a rag.

 

 

 

5. Apply the all-purpose glue or wood glue evenly on the back of the bamboo fiberboard, then affix the bamboo fiberboard to the wall surface, and then gently hammer the bamboo fiberboard with your hand to make the bamboo fiberboard stick to the wall more firmly. .

 

 

 

6. Transfer the water-filled joint filler material, then fill the joint material at the intersection of two bamboo fiberboard at a 45-degree angle, fill it first, and then gently cross the vertical angle of the wooden board from the intersection of 45 degrees, so that the intersection is beautiful. It is.

 

 

 

7. Clean the surface of the bamboo fiberboard and clean the excess joint filler.

 

 

 

Second, aluminum alloy fixed

 

 

 

1. Cover the wall with a base layer. Commonly used are 3MM plywood, wood board, good point is fireproof glass magnesium board, nailed to the wall with gas nails.

 

 

 

2. Stud the foot line on the wall. Fix the corner with the aluminum alloy corner and fix the corner with the aluminum alloy tool bar. That is, the aluminum alloy female corner and the aluminum alloy tool strip are respectively nailed to the corresponding positions on the wall surface.

 

 

 

3, then saw bamboo fiberboard. The UV panels are sawn into pieces according to the actual size required, and the saw edges are trimmed and cleaned with sandpaper.

 

 

 

4. Insert the bamboo fiberboard between the aluminum alloy corner and the tool bar.